Asus PIKE 2008/IMR - Manual (Page 42)

2-28 Chapter 2: RAID configuration
• Select Locate to make the LED flash on the drive. This works only if the drive
is installed in a drive enclosure.
• Select Stop Locate to disable the LED flash on the drive.
If the drive state is Unconfigured Good, four additional operations appear on this
screen:
• Select Make Global HSP to make a global hot spare, available to all of the
virtual drives.
• Select Enclosure Affinity so if there are drive failures present on a split
backplane configuration, then the hot spare will be used first on the backplane
side that it resides in.
• Select Make Unconf Bad to make the drive state to become Unconfigured
Bad.
• Select Prepare Removal to prepare the drive for removal from the enclosure.