Asus P5LD2-C/IPAT - Manual (Page 74)

4-18 Chapter 4: BIOS setup
Device Mode [STD Printer Mode]
Allows you to set the mode of Printer Port. Configuration options: [STD
Printer Mode] [SPP Mode] [EPP-1.9 and SPP Mode] [EPP-1.7 and SPP
Mode] [ECP Mode] [ECP and EPP 1.9 Mode] [ECP and EPP 1.7 Mode]
4.4.8 PCI Subsystem Settings
The items in this menu allow you to change the settings for PCI, PCI-X, and PCI
Express. Select an item then press to display the configuration options.
Value to be programmed
into PCI Latency Timer
Register.
PCI Settings
PCI Latency Timer [32 PCI Bus Clocks]
PCI Express Device Settings
Relaxed Ordering [Disabled]
Extended Tag [Disabled]
No Snoop [Enabled]
Maximum Payload [Auto]
Maximum Read Request [Auto]
PCI Express Link Settings
ASPM Support [Disabled]
WARNING: Enabling ASPM may cause some
PCI-E devices to fail
Extended Synch [Disabled]
PCI Latency Timer [32 PCI Bus Clocks]
Allows you to select the value to be programmed into PCI Latency Timer Regisster.
Configuration options: [32 PCI Bus Clocks] 64 PCI Bus Clocks] [96 PCI Bus
Clocks] [128 PCI Bus Clocks] [160 PCI Bus Clocks] [192 PCI Bus Clocks] [224 PCI
Bus Clocks] [248 PCI Bus Clocks]
Relaxed Ordering [Disabled]
Allows you to enable or disable PCI Express Device Relaxed Ordering.
Configuration options: [Disabled] [Enabled]
Extended Tag [Disabled]
Allows you to enable or disable Extened Tag. When enabled, it allows Device to
use 8-bit Tag field as a requester. Configuration options: [Disabled] [Enabled]
No Snoop [Enabled]
Allows you to enable or disable PCI Express Device No Snoop option.
Configuration options: [Disabled] [Enabled]