7 super io configuration, Floppy disk controller configuration – Asus P5LD2-C/IPAT User Manual
Page 72

4-16
Chapter 4: BIOS setup
Set Parameters of Floppy
Disk Controller (FDC)
4.4.7
Super IO Configuration
The items in this menu allow you to set or change the configurations for super IO
devices. Select an item then press
Super IO Configuration
Super IO Chip
Winbond W83627
Floopy Disk Controller Configuration
Serial Port Configuration
Parallel Port Controller Configuration
Floppy Disk Controller Configuration
Enable or Disable
Floppy Disk Controller
Floopy Disk Controller Configuration
Floopy Disk Controller
[Enabled]
Device Settings
Reset Required
Change Settings
[Auto]
Device Mode
[Read Write]
Floppy Disk Controller [Enabled]
Allows you to enable or disable the floppy disk controller.
Configuration options: [Disabled] [Enabled]
Change Settings [Auto]
Allows you to select an optimal settings for the super IO device.
Configuration options: [Auto] [IO=3F0h; IRQ=6; DMA=2] [IO=3F0h; IRQ=3, 4,
5, 6, 7, 10, 12; DMA=1, 2, 3;]
Device Mode [Read Write]
Allows you to set the mode of floppy disk controller. Selects Read Write mode
for normal operation. Selects Write Protect mode for read only operation.
Configuration options: [Read Write] [Write Protect]
The following item appears only when the Floppy Disk Controller item is set to
[Enabled].