Asus P5P800 SE - Manual (Page 33)

A S U S P 5 P 8 0 0 S E A S U S P 5 P 8 0 0 S E A S U S P 5 P 8 0 0 S E A S U S P 5 P 8 0 0 S E A S U S P 5 P 8 0 0 S E 2 - 1 3 2 - 1 3 2 - 1 3 2 - 1 3 2 - 1 3
2.4 System memory
2.4.1 2.4.1 2.4.1 2.4.1 2.4.1 Overview Overview Overview Overview Overview
The motherboard comes with four Double Data Rate (DDR) Dual Inline
Memory Modules (DIMM) sockets.
The following figure illustrates the location of the sockets:
2.4.2 2.4.2 2.4.2 2.4.2 2.4.2 Memory configurations Memory configurations Memory configurations Memory configurations Memory configurations
You may install 128MB, 256MB, 512MB, and 1GB DDR DIMMs into the DIMM
sockets using the memory configurations in this section.
Important notes Important notes Important notes Important notes Important notes
• Use the blue DIMM slots first.
• Make sure to unplug the power supply before adding or removing
DIMMs or other system components. Failure to do so may cause
severe damage to both the motherboard and the components.
1. For optimum compatibility, it is recommended that you obtain
memory modules from the same vendor. See the DDR400 Qualified
Vendor List (QVL) on page 2-15.
2. Make sure that the memory frequency matches the CPU FSB (Front
Side Bus). Refer to the M e m o r y f r e q u e n c y / C P U F S B M e m o r y f r e q u e n c y / C P U F S B M e m o r y f r e q u e n c y / C P U F S B M e m o r y f r e q u e n c y / C P U F S B M e m o r y f r e q u e n c y / C P U F S B
s y n c h r o n i z a t i o n s y n c h r o n i z a t i o n s y n c h r o n i z a t i o n s y n c h r o n i z a t i o n s y n c h r o n i z a t i o n table on page 2-14.
3. Always install DIMMs with the same CAS Latency.
4. DDR DIMMs made up of 128 Mb chips or double-sided DDR DIMMs
with x 1 6 x 1 6 x 1 6 x 1 6 x 1 6 (data bus=16bit) memory modules are not supported in
this motherboard.
P5P800 SE
®
P5P800 SE 184-pin DDR DIMM sockets
DIMM_A
1
DIMM_A
2
DIMM_B
1
DIMM_B
2