Asus WL-330N - Manual (Page 24)

3-4 Chapter 3: Utilities
Firmware Restoration
Firmware Restoration is used on an ASUS WL-330N that failed during its firmware
upgrading process. It uploads the firmware that you specify. The process takes
about three to four minutes.
To launch the rescue mode and use the Firmware Restoration utility:
1. Unplug the WL-330N from the power source.
2. Hold the Reset button at the rear panel and simultaneously re-plug the WL-
330N into the power source. Release the Reset button when the Power LED
at the front panel flashes slowly, which indicates that the WL-330N is in the
rescue mode.
3. Use the following to set up your TCP/IP settings:
IP address: 192.168.1.x
Subnet mask: 255.255.255.0
4. From your computer’s desktop, click Start > All Programs > ASUS Utility >
WL-330N Wireless Router > Firmware Restoration.
Launch the rescue mode before using the Firmware Restoration utility.