Asus Blitz Formula (Special Edition) - Manual (Page 61)

ROG Blitz Formula 2-35
5. IEEE 1394a port connector (10-1 pin IE1394_2)
This connector is for a IEEE 1394a port. Connect the IEEE 1394a module
cable to this connector, then install the module to a slot opening at the back
of the system chassis.
BLITZ FORMULA
®
BLITZ FORMULA IEEE 1394a connector
IE1394_2
PIN 1
GND +12V
TPB1-
GND
TP
A1-
+12V TPB1+ GND TP
A1+
Never connect a USB cable to the IEEE 1394a connector. Doing so will damage
the motherboard!
You can connect the 1394 cable to ASUS Q-Connector (1394, red) first, and
then install the Q-Connector (1394) to the 1394 connector onboard.
6. Thermal sensor cable connectors (2-pin OPT_TEMP1/2)
These connectors are for temperature monitoring. Connect the thermal
sensor cables to these connectors and place the other ends to the devices
which you want to monitor temperature. The optional fan1~2 can work with
the temperature sensors for a better cooling effect.
BLITZ FORMULA
®
BLITZ FORMULA Thermal sensor cable connectors
OPT_TEMP1
Te
mperature
Ground
Temperature
Ground
OPT_TEMP2
The thermal sensor cable is purchased separately.
Remove the thermal sensor cable from the assigned device when you set the
South Bridge Sensor Select item in BIOS to [SB Overheat Protection]. Refer
to page 4-31 for details.