Asus Maximus Formula - Manual (Page 58)

2-32 Chapter 2: Hardware information
5. IEEE 1394a port connector (10-1 pin IE1394_2)
This connector is for a IEEE 1394a port. Connect the IEEE 1394a module
cable to this connector, then install the module to a slot opening at the back
of the system chassis.
Never connect a USB cable to the IEEE 1394a connector. Doing so will damage
the motherboard!
You can connect the 1394 cable to ASUS Q-Connector (1394, red) first, and
then install the Q-Connector (1394) to the 1394 connector onboard.
6. Thermal sensor cable connectors (2-pin OPT_TEMP1/2/3)
These connectors are for temperature monitoring. Connect the thermal
sensor cables to these connectors and place the other ends to the devices
which you want to monitor temperature. The optional fan1/2/3 can work with
the temperature sensors for a better cooling effect.
The thermal sensor cable is purchased separately.
Enable OPT_TEMP1/2/3 Overheat Protection in BIOS if you connect thermal
sensor cables to these connectors. Refer to page 4-31 for details.
MAXIMUS FORMULA
®
PIN 1
GND +12V
TPB1-
GND
TP
A1-
+12V TPB1+ GND TP
A1+
MAXIMUS FORMULA(Special Edition)/
MAXIMUS FORMULA IEEE 1394a connector
IE1394_2
MAXIMUS FORMULA
®
MAXIMUS FORMULA(Special Edition)/
MAXIMUS FORMULA
Thermal sensor cable connectors
OPT_TEMP3
Temperature Ground
Temperature
Ground
OPT_TEMP2
Temperature Ground
OPT_TEMP1