Asus Maximus Formula - Manual (Page 105)

ROG Maximus Formula (Special Edition) / Maximus Formula 4-33
Select Screen
Select Item
+- Change Field
F1 General Help
F10 Save and Exit
ESC Exit
OPT_Fan 1 Reading :N/A
OPT_Fan1 Q-Fan Control [RATIO]
Duty Cycle Mode [90]
OPT_Fan 2 Reading :N/A
OPT_Fan2 Q-Fan Control [RATIO]
Duty Cycle Mode [90]
OPT_Fan 3 Reading :N/A
OPT_Fan3 Q-Fan Control [RATIO]
Duty Cycle Mode [90]
Power Fan Speed [N/A]
Fan configuration
mode setting
BIOS SETUP UTILITY
Power
v02.58 (C)Copyright 1985-2007, American Megatrends, Inc.
The onboard hardware monitor automatically detects the optional fan speed. If the
fan is not connected to the motherboard, the field shows N/A.
OPT_Fan1/2/3 Q-Fan Control [RATIO]
Allows you to select the optional fan control mode. When this item is set to
[DUTY CYCLE], you can configure the Duty Cycle Mode item. If you set this
item to [Q-FAN], you are allowed to configure the TargetTemp Value item.
The Q-Fan detects the temperature of the fan connected to the
OPT_FAN1/2/3 connector and adjusts the fan speed.
Configuraiton options: [RATIO] [Q-FAN]
You need to connect the thermal sensor cables to the OPT_TEMP1/2/3
connectors to enable this function.
OPT Q-Fan and Power Fan
Chassis Target Temperature [37ºC]
Configuration options: [28ºC] [31ºC] [34ºC] [37ºC] [40ºC] [43ºC] [46ºC]
Chassis Fan 3 Speed [xxxxRPM] or [Ignored] / [N/A]
The onboard hardware monitor automatically detects and displays the
chassis fan speed in rotations per minute (RPM). If the fan is not connected
to the motherboard, the field shows N/A.
Chassis Fan 3 Control [Disabled]
Allows you to enable or disable the chassis fan3 controller.
Configuration options: [Disabled] [Menu Mode] [Auto]
The following item appears when you set the Chassis Fan 3 Control to
[Menu Mode].
PWM Mode [50]
Configuration options: [50] [60] [70] [80] [90] [100%]