Asus P5B - Manual (Page 86)

4-22 Chapter 2: BIOS setup
Configure DRAM Timing by SPD [Enabled]
When this item is enabled, the DRAM timing parameters are set according to the
DRAM SPD (Serial Presence Detect). When disabled, you can manually set the
DRAM timing parameters through the DRAM sub-items. The following sub-items
appear when this item is Disabled. Configuration options: [Enabled] [Disabled]
DRAM CAS# Latency [5]
Controls the latency between the SDRAM read command and the time the
data actually becomes available. Configuration options: [3] [4] [5] [6]
DRAM RAS# to CAS# Delay [6 DRAM Clocks]
Controls the latency between the DDR SDRAM active command and the
read/write command. Configuration options: [2 DRAM Clocks] [3 DRAM
Clocks] [4 DRAM Clocks] [5 DRAM Clocks] [6 DRAM Clocks]
DRAM RAS# Precharge [6 DRAM Clocks]
Controls the idle clocks after issuing a precharge command to the DDR
SDRAM. Configuration options: [2 DRAM Clocks] [3 DRAM Clocks] [4 DRAM
Clocks] [5 DRAM Clocks] [6 DRAM Clocks]
DRAM RAS# Activate to Precha [15 DRAM Clocks]
Configuration options: [4 DRAM Clocks] [5 DRAM Clocks]...[18 DRAM Clocks]
Initiate Graphic Adapter [PEG/PCI]
Allows you to select the graphics controller as the primary boot device.
Configuration options: [PCI/PEG] [PEG/PCI]
PEG Force x1 [Disabled]
Configuration options: [Enabled] [Disabled]
4.4.5 Onboard Devices Configuration
HD Audio Controller [Enabled]
Front Panel Support Type [AC97]
Onboard PCIE GbE LAN [Enabled]
LAN Option ROM [Disabled]
JMicron SATA/PATA Controller [Enabled]
JMicron SATA Controller Mode [AHCI]
Serial Port1 Address [3F8/IRQ4]
Parallel Port Address [378]
Parallel Port Mode [ECP]
ECP Mode DMA Channel [DMA3]
Parallel Port IRQ [IRQ7]
HD Audio Controller [Enabled]
Allows you to enable or disable the High Definition Audio controller.
Configuration options: [Disabled] [Enabled]