Asus P5B - Manual (Page 47)

ASUS P5B 2-2
Refer to the audio configuration table below for the function of the audio ports in
2, 4, 6, or 8‑channel configuration.
Audio 2, 4, 6, or 8-channel configuration
Port Headset
2-channel
4-channel 6-channel 8-channel
Light Blue Line In Line In Line In Line In
Lime Line Out Front Speaker Out Front Speaker Out Front Speaker Out
Pink Mic In Mic In Mic In Mic In
Orange – – Center/Subwoofer Center/Subwoofer
Black – Rear Speaker Out Rear Speaker Out Rear Speaker Out
Gray – – – Side Speaker Out
10. USB 2.0 ports 3 and 4. These two -pin Universal Serial Bus (USB) ports
are available for connecting USB 2.0 devices.
11. USB 2.0 ports 1 and 2. These two -pin Universal Serial Bus (USB) ports
are available for connecting USB 2.0 devices.
12. External SATA port. This port connects to an external SATA box or a Serial
ATA port multiplier. This port supports a Serial ATA hard disk drive that you
can combine with an external Serial ATA 3.0 Gb/s device to configure a RAID
0, RAID , or JBOD set through the onboard JMicron SATA RAID controller.
• Before creating a RAID set using Serial ATA hard disks, make sure that you
have connected the Serial ATA signal cable and installed Serial ATA hard
disk drives; otherwise, you cannot enter the JMicron RAID utility and SATA
BIOS setup during POST.
• If you intend to create a RAID configuration using this connector, set the
JMicron SATA Controller Mode item in the BIOS to [RAID]. See section
“4.4.5 Onboard Device Configuration” for details.
The external SATA port supports
external Serial ATA
.0 Gb/s devices. Longer
cables support higher power
requirements to deliver signal up
to two meters away, and enables
improved hot-swap function.