Asus P5B - Manual (Page 125)

ASUS P5B 5-5
5.4.2 JMicron ® RAID Configuration
The JMicron ® Serial ATA controller allows you to configure RAID 0, RAID 1 and
JBOD sets on the external Serial ATA hard disk drives.
Before creating a RAID set
Prepare the following items:
. Two SATA HDDs, preferably with the same model and capacity.
2. A write-enabled floppy disk
. Microsoft
® Windows ® OS installation disk (Windows 2000/XP)
4. Motherboard support CD with JMB363 driver
Complete the following steps before you create a RAID set:
1. Install the external Serial ATA hard disk drives (HDDs) on your system.
. Set the JMicron SATA Controller Mode item in the BIOS to [RAID]. See
section “4.4.5 Onboard Devices Configuration” for details.
3. Enter the JMB363 RAID BIOS utility to set up your RAID configuration.
4. Create a JMB363 RAID driver disk for Windows
® OS installation. See section
“5.5 Creating a RAID/SATA driver disk” for details.
5. Install the JMB363 driver after the Windows ® OS had been installed.
HD Audio Controller [Enabled]
Front Panel Support Type [AC97]
Onboard PCIE GbE LAN [Enabled]
LAN Option ROM [Disabled]
JMicron SATA/PATA Controller [Enabled]
JMicron SATA Controller Mode [RAID]
Serial Port1 Address [3F8/IRQ4]
Parallel Port Address [378]
Parallel Port Mode [ECP]
ECP Mode DMA Channel [DMA3]
Parallel Port IRQ [IRQ7]