Asus P5-99B - Manual (Page 38)

III. HARDWARE SETUP
ASUS P5-99B User’s Manual 38
20. Wake-On-LAN Activity Connector (3-pin WOLCON)
The WOLCON connector allows the system to power up when there is a wakeup
packet or signal is received from the network through the ASUS PCI-L101 LAN
card (see ASUS LAN CARD).
IMPORTANT! This feature requires that the WAKE On LAN Power Up Control is
set to Enabled (see Power Management Setup under BIOS SETUP) and that your
system has an ATX power supply with at least 720mA +5V standby power.
P5-99B Wake-On-LAN Connector
+5 VSB PME
Ground
0 1
21. Wake-On-Ring Connector (2-pin WOR)
The WOR connector connects to internal modem cards with Wake-On-Ring out-
put. The connector powers up the system when a ringup packet or signal is re-
ceived through the internal modem card. NOTE: For external modems, Wake-
On-Ring is detected through the COM port.
IMPORTANT! This feature requires that the PWR UP On Modem Act Power
Up Control is set to Enabled (see Power Management Setup under BIOS SETUP)
and that your system has an ATX power supply with at elast 720mA +5V standby
power.
0 1
WOR
Pin2 Ring#
Pin1 Ground
P5-99B Wake-On-Ring Connector
Connectors
III. H/W SETUP