Asus P8H77-M PRO - Manual (Page 43)

ASUS P8H77-M PRO 2-23
Chapter 2
3. Marvell ® Serial ATA 6.0Gb/s connectors (7-pin SATA6G_E1 [navy blue])
This connector connects to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0 Gb/s
signal cables.
• The SATA6G_E1 (navy blue) connectors are for data drives only. ATAPI devices are
not supported.
• You must install Windows ® XP Service Pack 3 or later versions before using Serial ATA
hard disk drives.
• When using NCQ, set the Marvell Storage Controller item in the BIOS to [Enabled].
Refer to section 3.5.6 Onboard Devices Configuration for details.
P8H77-M PRO
P8H77-M PRO Marvell ® SATA 6.0 Gb/s connectors
SATA6G_E1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
4. USB 3.0 connector (20-1 pin USB3_34)
This connector is for additional USB 3.0 ports, and complies with the USB 3.0
specification that supports up to 4.8Gbps connection speed. If the USB 3.0 front panel
cable is available on your system chassis, this USB 3.0 connector can be used to
install USB 3.0 ports on the front panel.
You can connect the ASUS front panel USB 3.0 bracket to this connector.
P8H77-M PRO
P8H77-M PRO USB3.0 Front panel connector
USB3_34
The USB 3.0 bracket is purchased separately.