Asus CUV266 - Manual (Page 68)

ASUS CUV266 User’s Manual 68
4. BIOS SETUP
4. BIOS SETUP I/O Device Config
Onboard Peripheral Resource Control
Parallel Port Mode [ECP+EPP]
This field allows you to set the operation mode of the parallel port. [Normal] allows
normal-speed operation but in one direction only; [EPP] allows bidirectional parallel
port operation; [ECP] allows the parallel port to operate in bidirectional DMA mode;
[ECP+EPP] allows normal speed operation in a two-way mode. Configuration options:
[Normal] [EPP] [ECP] [ECP+EPP]
ECP DMA Select [3]
This field allows you to configure the parallel port DMA channel for the selected ECP
mode. This selection is available only if you select [ECP] or [ECP+EPP] in Parallel
Port Mode above. Configuration options: [1] [3] [Disabled]
Onboard AC97 Modem Controller [Auto]
Onboard AC97 Audio Controller [Auto]
[Auto] allows the BIOS to detect whether you are using any modem/audio device. If a
modem/audio device is detected, the onboard modem/audio controller is enabled; if no
modem/audio device is detected, the controller is disabled. If there are conflicts with
the onboard modem/audio controller, set the appropriate field to [Disabled].
Configuration options: [Disabled] [Auto]
Onboard CIR I/O [Disabled]
This field allows you to select the I/O address and IRQ for consumer infrared device.
Configuration options: [Disabled] [2E0-2E8H] [3E0-3E8H]