Asus M2A-VM HDMI - Manual (Page 84)

2-34 Chapter 2: BIOS setup
Typematic Rate (Chars/Sec) [6]
Allows you to select the rate at which a character repeats when you hold a
key. Configuration options: [6] [8] [10] [12] [15] [20] [24] [30]
Typematic Delay (Msec) [250]
Allows you to set the delay before keystrokes begin to repeat. Configuration
options: [250] [500] [750] [1000]
OS.Select.for.DRAM.>.64MB.[Non-OS2]
Set this item to OS2 only when you are running on an OS/2 operating system with
an installed RAM of greater than 64 KB.
Configuration options: [Non-OS2] [OS2]
Bootup Num-Lock [On]
Allows you to select the power-on state for the NumLock.
Configuration options: [Off] [On]
Typematic.Rate.Setting.[Disabled]
Allows you to set the keystroke rate. Enable this item to configure the Typematic
Rate (Chars/Sec) and the Typematic Delay (Msec).
Configuration options: [Disabled] [Enabled]
The items Typematic Rate (Chars/Sec) and Typematic Delay (Msec) become
user-configurable only when the item Typematic Rate Setting is enabled.
Full Screen LOGO [Enabled]
Allows you to enable or disable the full screen logo display feature. Configuration
options: [Disabled] [Enabled]
Halt On [All, But Keyboard]
Allows you to error report type.
Configuration options: [All Errors] [No Errors] [All, But Keyboard] [All, But Diskette]
[All, But Disk/Key]
Make sure that the above item is set to [Enabled] if you want to use the ASUS
MyLogo2™ feature.
Boot.Up.Floppy.Seek.[Disabled]
Enables or disables the chassis open status feature. Setting to Enabled, clears the
chassis open status. Configuration options: [Disabled] [Enabled]