Asus AP1600R-E2(BI2) - Manual (Page 28)

C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p 2 - 1 2 2 - 1 2 2 - 1 2 2 - 1 2 2 - 1 2
8. Connect the 40-pin IDE cable
and a 4-pin power plug to their
respective connectors on the
back of the drive.
5. Secure the tray with a screw.
6. Repeat steps 2 to 5 if you wish
to install a second HDD;
otherwise, proceed to step 7.
The other end of the IDE cable is pre-connected to the primary IDE
connector on the motherboard.
4. Carefully place the tray with
installed hard disk drive into the
drive bay. Slide it forward until
the front end aligns with the
front panel, and the screw hole
matches the standoff.
7. Reinstall the fan control board.
Secure the board with five
screws.
4 0 - p i n I D E c a b l e 4 0 - p i n I D E c a b l e 4 0 - p i n I D E c a b l e 4 0 - p i n I D E c a b l e 4 0 - p i n I D E c a b l e
4 - p i n p o w e r p l u g 4 - p i n p o w e r p l u g 4 - p i n p o w e r p l u g 4 - p i n p o w e r p l u g 4 - p i n p o w e r p l u g