Mediashield™ raid controller, P5n32-e sli plus ide connector, Pri_ide – Asus P5N32-E SLI Plus User Manual
Page 53: P5n32-e sli plus sata connectors sata1, Sata2, Sata3, Sata4, Sata5, Sata6, Pin 1

ASUS P5N32-E SLI Plus
2-27
3. Serial ATA connectors (7-pin SATA1-6)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID
1, RAID 0+1, RAID 5, or JBOD configuration with the onboard NVIDIA
with the onboard NVIDIA
®
MediaShield™ RAID controller.
The RAID function of these connectors is set to [Disabled] by default. If you
intend to create a Serial ATA RAID set using these connectors, enable the RAID
Enabled item under the Serial ATA Configuration sub-menu in the BIOS. See
section “4.5.3 Onboard Device Configuration” for details.
These connectors support Native Command Queuing (NCQ), Power
Management (PM) Implementation Algorithm, Hot Swap and smart setup.
P5N32-E SLI Plus
®
P5N32-E SLI Plus IDE connector
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PRI_IDE
PIN 1
P5N32-E SLI Plus
®
P5N32-E SLI Plus SATA connectors
SATA1
GND
RSA
TA
_TXP1
RSA
TA
_TXN1
GND
RSA
TA
_RXP1
RSA
TA
_RXN1
GND
SATA2
GND
RSA
TA
_TXP2
RSA
TA
_TXN2
GND
RSA
TA
_RXP2
RSA
TA
_RXN2
GND
SATA3
GND
RSA
TA
_TXP3
RSA
TA
_TXN3
GND
RSA
TA
_RXP3
RSA
TA
_RXN3
GND
SATA4
GND
RSA
TA
_TXP4
RSA
TA
_TXN4
GND
RSA
TA
_RXP4
RSA
TA
_RXN4
GND
SATA5
GND
RSA
TA
_TXP5
RSA
TA
_TXN5
GND
RSA
TA
_RXP5
RSA
TA
_RXN5
GND
SATA6
GND
RSA
TA
_TXP6
RSA
TA
_TXN6
GND
RSA
TA
_RXP6
RSA
TA
_RXN6
GND