Asus WL-600g - Manual (Page 37)

WL-600g All-in-1 Wireless ADSL2/2+ Home Gateway User Manual
35
Setting up DMZ host
The function of DMZ is similar to that of virtual server. The difference between virtual
server and DMZ is that DMZ opens all ports to WAN while virtual server opens ports
according to the demand of the enabled services. To configure DMZ host:
1. Click
Advanced Setup -> NAT -> DMZ Host in the left side menu to open the
configuration page.
2. Enter the IP address of the host to be setup as DMZ host.
3. Press
Save/Apply to activate the settings.
Allowing SIP request through NAT
NAT checks IP header only and translate the information into private IP address.
However, for applications that demand many dynamic ports for session control such as
Session Initiation Protocol (SIP), traditional NAT cannot translate the address because
lack of preset service ports. To enable such services while at the same time do not
sacrifice network security, WL-600g introduces Application Layer Gateway (ALG) to
allow SIP request going through fireware and NAT from WAN. To configure ALG:
1. Click
Advanced Setup -> NAT -> ALG in the left side menu to open the
configuration page.
2. Select SIP Enabled checkbox to allow SIP request, or uncheck to disable.
3. Press Save/Apply to save and activate the settings.
Firewall - Outgoing IP filter
By default, all outbound IP traffic is allowed. You can block certain types of IP traffic by
setting up filter rules at WL-600g.
1. Click
Advanced Setup -> Security -> IP Filtering -> Outgoing in the left side
menu to open the configuration page. Click Add to create a new rule.