Asus P4V8X-MX - Manual (Page 70)

ASUS P4V8X-MX Motherboard 3-9
RAID 1 for data protection
1. From the create array menu, select Array Mode, then press . The
supported RAID configurations appear on a pop-up menu.
RAID 0 for performance
RAID 1 for data protection
RAID SPAN for capacity
RAID 1 for data protection
2. Select RAID 1 for data protection then press .
8. If you select the utility will duplicate your data. Press anytime if you
want to exit the duplication process.
3. From this point, you can auto-configure the RAID array by selecting Auto
Setup for Data Security or manually configure the RAID array for mirrored
sets. If you want to auto-configure, proceed to the next step, otherwise, skip
to step 6.
4. Select Auto Setup for Data Security and press . The following
confirmation message appears.
Auto create array will destroy all
data on disks, Continue? (Y/N)
5. Press to confirm or to return to the configuration options. If you
selected , proceed to step 11.
6. Select Select Disk Drives, then press . Use arrow keys to select disk
drive/s, then press . An asterisk appears before a selected drive.
7. Select Start Create Process and press to setup hard disk for RAID
system. The following inquiry appears:
Save the data on source disk to
mirror after creation? (Y/N)
The data on the selected disks will
be destroyed. Continue? (Y/N)
10. Press to confirm or to return to the configuration options.
11. Press to go back to main menu.
Duplicating...
RAID 1 for data protection
Press CTRL+E to Escape
9. If you select , the following confirmation message appears.