Asus P4V8X-MX - Manual (Page 31)

1-22 Chapter 1: Product Introduction
9. Chassis intrusion connector (4-1 pin CHASSIS)
This lead is for a chassis designed with intrusion detection feature. This
requires an external detection mechanism such as a chassis intrusion sensor
or microswitch. When you remove any chassis component, the sensor
triggers and sends a high-level signal to this lead to record a chassis intrusion
event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a
jumper cap. If you wish to use the chassis intrusion detection feature, remove
the jumper cap from the pins.
10. Digital audio connector (3- pin SPDIF)
This connector is for the S/PDIF audio module that allows digital sound input.
• Use 75 ohm impedance matched coaxial cables for your S/PDIF connection.
• The S/PDIF module is purchased separately.
P 4 V 8 X - M X
R
P4V8X-MX Chassis Intrusion Connectors
CHASSIS
+5VSB_MB Chassis Signal GN
D
(Default)
P 4 V 8 X - M X
R
+5V SPDIFOUT GN
D
SPDIF_OUT
P4V8X-MX Digital Audio Connector