Asus WL-320gP - Manual (Page 38)

3. Software
38 ASUS 802.11g Access Point
Chapter 3 - Software Configuration
Access Point
DTIM Interval (1-255) – DTIM (Delivery Traffic Indication Message) is
a wireless message used to inform clients in Power Saving Mode when the
system should wake up to receive broadcast and multicast messages. Type
the time interval in which the system will broadcast a DTIM for clients in
Power Saving Mode. The default value (3) is recommended
Beacon Interval (1-65535) – This field indicates the time interval
in milliseconds that a system broadcast packet, or beacon, is sent to
synchronize the wireless network. The default value (100 milliseconds) is
recommended.
Enable Frame Bursting? – This field allows you to enable frame-bursting
mode to improve performance with wireless clients that also support frame-
bursting.
Radio Power – Radio Power can be set between 1 to 84 but the default
value is recommended.
Enable WMM – This field allows you to enable WMM to improve
multimedia transmission
Enable WMM No-Acknowledgement – This field allows you to enable
WMM No-Acknowledgement
Mode – This field allows you set up different operation modes(AP or WDS,
Station or URE) either in AP mode or Gateway mode.
URE – This section allows you set up parameters for URE. This section
only works while in URE mode.
SSID – This is the SSID of root AP. The ASUS 802.11g AP can repeat the
signal and boost the signal coverage while setting in URE mode.
Other security parameters settings are the same as those in Wireless ->
Interface.