Asus AT5IONT-I - Manual (Page 19)

ASUS AT5IONT-I Series 1-10
1. Serial ATA connectors (7-pin SATA1, SATA2)
These connectors are for the Serial ATA signal cables for Serial ATA 3Gb/s hard disk
drives and optical disk drives. The Serial ATA 3Gb/s is backward compatible with the
Serial ATA 1.5Gb/s specification. The data transfer rate of the Serial ATA 3Gb/s is faster
than the standard parallel ATA (133 MB/s).
• Install the Windows ® XP Service Pack 2 or later versions before using Serial ATA.
1.7.2 Internal connectors
SATA1
GN
D
RSATA_RXN1 RSATA_RXP1 GN
D
RSATA_TXN1 RSATA_TXP1 GN
D
SATA2
GN
D
RSATA_TXP2 RSATA_TXN2
GN
D
RSATA_RXP2 RSATA_RXN2
GN
D
AT5IONT-I DELUXE
AT5IONT-I DELUXE SATA connectors
2. ATX power connector (24-pin EATXPWR) (for AT5IONT-I only)
This connector is for an ATX power supply. The plug from the power supply is designed
to fit this connector in only one orientation. Find the proper orientation and push down
firmly until the connector completely fits.
• For a fully configured system, we recommend that you use a power supply unit (PSU)
that complies with ATX 12 V Specification 2.0 (or later version) and provides a minimum
power of 90 W.
• We recommend that you use a PSU with higher power output when configuring a
system with more power-consuming devices. The system may become unstable or may
not boot up if the power is inadequate.
• If you are uncertain about the minimum power supply requirement for your system,
refer to the Recommended Power Supply Wattage Calculator at http://support.asus.
com/PowerSupplyCalculator/PSCalculator.aspx?SLanguage=en-us for details.
AT5IONT-I
AT5IONT-I ATX power connector