Asus AT5IONT-I - Manual (Page 20)

1-11 Chapter 1: Product introduction
3. USB connector (10-1 pin USB56)
This connector is for a USB 2.0 port. Connect the USB module cable to this connector,
then install the module to a slot opening at the back of the system chassis. This USB
connector complys with USB 2.0 specification that supports up to 480 Mbps connection
speed.
Never connect a 1394 cable to the USB connector. Doing so will damage the motherboard!
The USB module cable is purchased separately.
AT5IONT-I DELUXE
AT5IONT-I DELUXE USB2.0 connector
PIN 1
USB56
Insufficient air flow inside the system may damage the motherboard components. These
are not jumpers! Do not place jumper caps on the fan connectors!
4. CPU, power, and chassis fan connectors (3-pin CPU_FAN, 3-pin PWR_FAN, 3-pin
CHA_FAN)
Connect the fan cables to the fan connectors on the motherboard, ensuring that the
black wire of each cable matches the ground pin of the connector.
AT5IONT-I DELUXE
AT5IONT-I DELUXE fan connectors
CPU_FAN PWR_FAN
Rotation
+12V GN
D
Rotation
+12V GN
D
CHA_FAN
GND
+12V
Rotation