Asus M3A78-EMH HDMI - Manual (Page 46)

1-34 Chapter 1: Product introduction
4.. Serial.ATA.connectors... . . . .
(7-pin SATA1, SATA2, SATA3, SATA4, SATA5, SATA6)
These connectors are for the Serial ATA signal cables for Serial ATA
3Gb/s hard disk and optical disk drives. The Serial ATA 3Gb/s is backward
compatible with Serial ATA 1.5Gb/s specification. The data transfer rate of the
Serial ATA 3Gb/s is faster than the standard parallel ATA with 133 MB/s (Ultra
DMA133).
If you install Serial ATA hard disk drives, you can create a RAID 0, RAID 1,
and RAID 10 configuration through the onboard SB700 controller.
Important.note.on.Serial.ATA
Install the Windows
® XP Service Pack 1 before using Serial ATA.
• For detailed instructions on how to configure RAID 0, RAID 1, and
RAID 10, refer to the RAID manual in the support DVD.
• If you intend to create a Serial ATA RAID set using these connectors, set
the OnChip.SATA.Type item in the BIOS to [RAID]. See
page 2-20 for details.
• If you change the OnChip.SATA.Type item in the BIOS to [RAID] or
[AHCI], set the SATA.IDE.Combined.Mode to [Disabled].to make
sure SATA5 and SATA6 (the black ports) work normally.
• If you want to do the task as GHOST, we suggest you connect the original
disk to the SATA5 or SATA6.
GND
RSATA_TXP4
RSATA_TXN4
GND
RSATA_RXP4
RSATA_RXN4
GND
SATA4
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
SATA1
GND
RSATA_TXP5
RSATA_TXN5
GND
RSATA_RXP5
RSATA_RXN5
GND
SATA5
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND
SATA2
GND
RSATA_TXP6
RSATA_TXN6
GND
RSATA_RXP6
RSATA_RXN6
GND
SATA6
GND
RSATA_TXP3
RSATA_TXN3
GND
RSATA_RXP3
RSATA_RXN3
GND
SATA3
M3A78-EMH HDMI SATA Connectors
M3A78-EMH HDMI