Asus P2-99B - Manual (Page 34)

34 ASUS P2-99B User’s Manual
III. HARDWARE SETUP
Connectors
III. H/W SETUP
18. Wake-On-Ring Connector (2-pin WOR)
This connector connects to an internal modem card with a Wake-On-Ring output.
The connector powers up the system when a ringup packet or signal is received
through the internal modem card. NOTE: For external modems, Wake-On-Ring
is detected through the COM port.
IMPORTANT: This feature requires that PWR UP On Modem Act Power Up
Control is set to Enabled (see Power Management Setup under BIOS SETUP)
and that your system has an ATX power supply with at least 720mA +5V standby
power.
P2-99B Wake-On-Ring Connector
WOR
R
P2-99B
Pin 2 PIXRI#
Pin 1 Ground
19. Chassis Intrusion Sensor Lead (optional) (4-1 pin CHASIS)
This lead is for a chassis intrusion monitor or sensor. The sensor is triggered
when a high level signal is sent to the “chassis signal” lead. This occurs when a
panel switch or light detector is triggered. This function requires the optional
ASUS CIDB Chassis Intrusion Photo Sensor Module (see APPENDIX) to be
installed.
P2-99B Chassis Open Alarm Lead
+5V
olt (Power Supply Stand By)
Ground Chassis Signal R
P2-99B