Asus P2-99B - Manual (Page 31)

ASUS P2-99B User’s Manual 31
III. HARDWARE SETUP
7. Chassis, CPU , & Power Supply Fan Connectors (3-pin CHA_, CPU_, PWR_FAN)
These connectors support cooling fans of 500mA (6 Watts) or less. Orientate
the fans so that the heat sink fins allow airflow to go across the onboard heat
sink(s) instead of the expansion slots. Depending on the fan manufacturer, the
wiring and plug may be different. The red wire should be positive, while the
black should be ground. Connect the fan’s plug to the board taking into consid-
eration the polarity of the this connector. NOTE: The “Rotation” signal is to
be used only by a specially designed fan with rotation signal.
WARNING! These connectors have power. Damage may occur to the mother-
board and/or the CPU fan if these connectors are incorrectly used.
P2-99B 12Volt Cooling Fan Power
Chassis Fan Power (CHA_FAN)
Power Supply Fan (PWR_FAN)
CPU Fan Power (CPU_FAN)
GND Rotation +12V
R
P2-99B
GND
Rotation
+12V
GND
Rotation
+12V
8. Wake-On-LAN Connector (3-pin WOL_CON)
This connector connects to a LAN card with a Wake-On-LAN output, such as
the ASUS PCI-L101. The LAN card powers up the system when a wakeup
packet or signal is received from the network.
IMPORTANT: This feature requires that the WAKE On LAN Power Up Con-
trol is set to Enabled (see Power Management Setup under BIOS SETUP) and
that your system has an ATX power supply with at least 720mA +5V standby
power.
P2-99B Wake-On-LAN Connector
R
+5 VSB PME
Ground
P2-99B
Connectors
III. H/W SETUP