beautypg.com

Iii. hardware setup – Asus P2-99B User Manual

Page 13

background image

ASUS P2-99B User’s Manual

13

III. HARDWARE SETUP

Motherboard Settings

1) KBPWR

p. 14 Keyboard Power Up

2) VIO

p. 15 VIO Selection

3) VCORE

p. 15 Voltage Regulator Output Selection

4) FS0, FS1, FS2, FS3

p. 16 CPU External Frequency Selection

5) BF0, BF1, BF2, BF3

p. 16 CPU Core:External Frequency Multiple

Expansion Slots/Sockets

1) System Memory

p. 18 System Memory Support

2) DIMM Sockets

p. 19 DIMM Memory Module Support

3) Slot 1

p. 21 CPU Support

4) SLOT1, SLOT2

p. 26 16-bit ISA Bus Expansion Slots

*

5) PCI1, PCI2, PCI3

p. 26 32-bit PCI Bus Expansion Slots

6) AGP

p. 27 Accelerated Graphics Port

Hardware Monitor (optional)

1) RT2, RT3

p. 25 Thermal Sensor Connectors

Connectors

1) KB-PS2KB

p. 28 Keyboard Port Connector (6-pin female)

2) FLOPPY

p. 28 Floppy Disk Drive Connector (34-1 pins)

3) PARALLEL

p. 29 Parallel Port Connector (25-pin female)

4) COM1, COM2

p. 29 Serial Port Headers (9-pin male)

5) PRIMARY/SECONDARY IDE p. 30 Primary/Secondary IDE Connectors (Two 40-1pins)
6) IDELED

p. 30 IDE Activity LED Lead (2 pins)

7) CHA_, CPU_, PWR_FAN

p. 31 Chassis, CPU, Power Supply Fan Connectors (Three 3-pin)

8) WOL_CON

p. 31 Wake-On-LAN Connector (3 pins)

9) MSG.LED (PANEL)

p. 32 System Message LED Lead (2 pins)

10) SMI (PANEL)

p. 32 System Management Interrupt Switch Lead (2 pins)

11) PWR.SW (PANEL)

p. 32 ATX Power & Soft-Off Switch Lead (2 pins)

12) RESET (PANEL)

p. 32 Reset Switch Lead (2 pins)

13) PWR.LED (PANEL)

p. 32 System Power LED Lead (3-1 pins)

14) KEYLOCK (PANEL)

p. 32 Keyboard Lock Switch Lead (2 pins)

15) SPEAKER (PANEL)

p. 32 System Warning Speaker Connector (4 pins)

16) USB/MIR

P. 33 USB, Infrared, PS/2 Module Connector (18-1 pins)

17) IR

p. 33 IrDA-Compliant Infrared Module Connector (5 pins)

18) WOR

p. 34 Wake-On-Ring Connector (2 pins)

19) CHASIS

p. 34 Chassis Intrusion Sensor Lead (4-1 pins)

20) SBLINK

p. 35 SB-Link

TM

Connector (6-1 pins)

21) SMB

p. 35 SMBus Connector (5-1 pins)

22) ATXPWR

p. 36 ATX Power Supply Connector (20 pins)

23) PS/2

p. 36 AT Power Supply Connector (20 pins)

*

The optional onboard hardware monitor uses the address 290H-297H so legacy ISA cards

must not use this address otherwise conflicts will occur.

Layout Contents

III. H/W SETUP