Asus Terminator P-III - Manual (Page 25)

ASUS Terminator Barebone System 25
2.9 Re-connect Cables
You may have disconnected some cables when you were installing
components. You must re-connect these cables before you replace
the chassis cover.
The figures below show the front panel cables and their corresponding
connectors on the motherboard.
1. Connect the power switch and power LED cables to their
respective leads in the PANEL connector on the motherboard.
2. Connect the HDD LED cable to the 2-pin lead marked IDELED.
3. Connect the Line Out/Mic cable to the FLOUT/MIC2 connector
on the motherboard, matching the red pin stripe with Pin 1.
4. Connect the USB2P cable to the USB1 connector on the
motherboard, matching the red pin stripe with Pin 1.
FLOUT Lead (for Line Out Cable)
MIC2 Lead (for Microphone Cable)
PANEL Connector
IDELED Lead
USB1 Connector
* Requires an ATX power supply.
PLED
Ground
TB_LED
PWR
+5 V
+5V
Speaker Ground
+5 V
ExtSMI#
Ground
Reset
Ground
Ground
Power LED
Speaker
Connector
Message LED
SMI Lead
Reset SW
ATX Power
Switch*
Pin 1
Power Switch
Power LED
HDD LED
Line Out / Mic
USB Connector (USB2P)