Acclaim specifications – theatre seating – Theatre Solution Acclaim Auditorium Seating User Manual

Page 25

Specifications Acclaim Auditorium Seating

Acclaim Specifications – Theatre Seating

(This section pertains to all models of the Acclaim chair.)

PART 4 – WARRANTY

4.1 The theater seating manufacturer must provide a Lifetime Warranty to the original purchaser of the seating as

follows:

A. The seating manufacturer shall warrant it’s products against failures and manufacturing defects for the life

of the product. This warranty applies to the original purchaser and is non-transferable. The seating
manufacturer will provide parts and labor to replace defective parts for the first two years after the
installation. Thereafter, the manufacturer will provide replacement parts for the life of the product.

B. This warranty shall not cover damage from abuse, misuse, neglect, or act of God. Damage caused by

modifications to the product by anyone other than a TSI authorized seating installation technician will void
this warranty. This warranty does not apply to fabrics or products not installed by TSI authorized seating
installation technicians.

PART 5 - EXECUTION

5.1 EXAMINATION

A. Examine site conditions, with installer present, for compliance with requirements for construction tolerances

as they affect anchors and fasteners, and location of junction boxes.

B. Do not proceed until unsatisfactory conditions have been corrected.

5.2 GENERAL

A. Comply with seating manufacturer’s printed installation instructions applicable to products.

B. Locate seating in locations indicated on approved shop drawings, with required clearances.

C. Install standards in locations conforming to seating layout, with each standard attached to substrate by no

less than two anchoring devices of size and type required to insure that chairs are stable under conditions
of actual use.

D. Install chairs using manufacturer’s recommended hardware and fasteners. Insure that chairs in curved

rows are installed on proper radius and are oriented toward the center point of the radius. Verify that
moving components operate smoothly and quietly.

5.3 ADJUSTING

A. Adjust as required to assure that the seats in each row are aligned when in the upright position.

B. Touch-up minor abrasions and imperfections in painted finishes with coating that matches factory-applied

finish.

C. Replace any upholstery that has been damaged during installation.

END OF SPECIFICATION