Theatre Solution Acclaim Auditorium Seating - Manual (Page 22)

Acclaim Auditorium Seating Specifications 21
C. Back Construction: The back panel shall be 1/2” thick, electronically glued curved hardwood plywood. The
padding material shall be 2” thick polyurethane foam, shall be glued to the inner panel, and shall conform to
the California Bureau of Home Furnishings Technical Bulletin 117. The outside surface of the back panel
shall be encapsulated in 1/4” thick slab polyurethane foam. The complete back assembly shall be
supported by four 11 gauge formed steel brackets.
D. Armrests: Shall be kiln-dried solid hardwood, nominally 3/4” thick x 2-1/4” wide x 12” long, stained to match
the outer back panels. The armrest will be fastened to the steel frame with two #8 x 3/4” pan head sheet
metal screws. Chairs equipped with tablet arms shall have armrests nominally 3/4” thick x 2-1/4” wide x
17-1/2” long and shall be attached to the steel frame arm support with three #8 x 3/4” pan head sheet metal
screws.
E. Hinge: The seat hinge shall be a weldment consisting of two stamped and formed 14 gauge plates. Hinges
shall include two recessed slots to accept 1/4-20 fillister head screws and one pierced, extruded and
reamed hole for assembly to the chair frame. Each hinge shall include a rubber bumper to dampen noise
upon the seat return to the vertical position. Compensating type hinges will not be acceptable.