Q-Tech QT88ND - Manual (Page 5)

MIL-PRF-55310/35B
5
Vibration, sinusoidal: In accordance with MIL-PRF-55310 and method 204 of MIL-STD-202 .
Nonoperating: Test condition G.
Operating: Not required.
Ambient pressure:
Nonoperating: In accordance with
MIL-PRF-55310 .
Operating:
Method 105 of MIL-STD-202 , test condition C.
Exposure time: 5 minutes.
Reflow soldering: Reflow soldering of the unit at +230
°C ±10°C for 15 seconds shall not degrade the performance.
Part or Identifying Number (PIN): Consists of “M” prefix followed by specification sheet number, a dash and coded
alphas, and numeric number. See example:
EXAMPLE
M55310/35- S 01 A XXXXXXXX
M prefix and specification sheet number
Product level (S, B, or C)
Dash number (see table I)
Operating temperature range
(A, B, or C) (see table I)
Frequency
Referenced documents. In addition to
MIL-PRF-55310 , this document references MIL-STD-202 .
The margins of this specification are marked with vertical lines to indicate where changes from the previous issue
were made. This was done as a convenience only and the Government assumes no liability whatsoever for any
inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document
based on the entire content irrespective of the marginal notations and relationship to the last previous issue.