Q-Tech QT816 Sine Wave - Manual (Page 8)

Q-TECH Corporation
10150 W. Jefferson Blvd.
Culver City, CA 90232
SIZE
A
CAGE NO.
51774
QT814, QT815 and QT816
Sine-Wave 24 Flat Pack REV.
E
Page 8 of 10
3.6 Data
3.6.1. Design Documentation - When required by the purchase order, design, topography, process and flow
charts for all assembly/inspection and test operation for devices to be supplied under this specification
on the initial procurement shall be established and shall be available in-plant for review by the
procuring activity upon request. This design documentation shall be sufficient to depict the physical
and electrical construction of the devices supplied under the specification and shall be traceable to the
specific parts, drawings or part type numbers to which it applies, and to the production lot(s) and
inspection lot codes under which devices are manufactured and tested so that revisions can be
identified.
3.6.2. Technical Data Package - When required by the purchase order, the following design documentation
and information is deliverable 30 days prior to the start of production. The Technical Data Package shall
consist of the following:
a) Assembly drawing(s).
b) All electrical schematics and drawings not considered proprietary .
c) The assembly and screening travelers to be used on-line to manufacture the devices supplied to
this specification.
d) Parts and materials list.
e) Element evaluation data confirming compliance with MIL-PRF-38534, Class K, and
Prohibited Materials paragraph 3.4. 3
3.7 Test Report
A test report is supplied with each shipment of oscillators and includes the following information, as a
minimum:
a) A Certificate of Conformance to all specifications and purchase order requirements. As a minimum,
the Certificate of Conformance shall include the following information:
Purchase order number.
Applicable part number.
Manufacturers lot number.
Lot date code.
b) Parts and materials traceability information.
c) Certificate of crystal sweeping.
d) Manufacturing lot traveler.
e) Screening attributes and variables data as applicable.
f) Quality conformance inspection attributes and variables data as applicable.
g) Radiographic inspection negatives.
3.8 Engineering Models
Engineering Models are fit, form, and function representative of Flight Models and of commercial
construction using commercial parts of same generic type as Flight Models. Completed oscillators are
not screened.