Q-Tech QT92RD - Manual (Page 2)

MIL-PRF-55310/40B
2
REQUIREMENTS:
Interface and physical dimensions: See
figure 1 .
Mounting: See
figure 1 .
Terminals: See
figure 1 .
Seal: Hermetic in accordance with
MIL-PRF-55310 , maximum leakage rate 5 x 10 -8 atm cc/s.
Weight: 3 grams, maximum.
Oscillator: Class 2 or any class 1 or class 3 oscillator meeting all class 2 requirements and verification tests
specified herein and in
MIL-PRF-55310 .
Calibration: Manufacturer calibrated.
Screening: In accordance with
MIL-PRF-55310 , product level B or S, as applicable.
Temperature:
Operating: See
table I .
Storage: -62
°C to +125°C.
Load test circuit: See
figure 2 .
Output waveform: Symmetrical square wave, 1.8 volt CMOS logic compatible (see
figure 3 ).
Output logic voltage levels at designated CMOS (see
figure 3 ):
Logic 1: 90 percent of V
DD
, minimum.
Logic 0: 10 percent of V
DD
, maximum.
Rise and fall times: (See table I) Measurements shall be taken at the 10 percent and 90 percent peak-to
-peak output voltage levels, with peak-to-peak output defined as level 1-level 0 (see figure 3).
Duty cycle: See
table I and figure 3 .
Supply voltage: +1.8 V dc
±10 percent.
Input current: At designated supply voltage (see
table I ).
Enable/disable:
Output disabled (high impedance): Pin 1 input
≤ 0.3 x Vdd
Output active: Pin 1 input
≥ 0.7x Vdd dc or open.
Output frequency: Frequency as designated at time of acquisition (see
table I ).
Initial accuracy at reference temperature (up to 30 days after shipment): See
table I .