SCANTECH ID (Champtek company) Pollux P-4010 - Manual (Page 19)

Instructions for installation on a counter surface are given in Section 2.1.
Due to many POS systems on the market, a large number of communication
cables is available. Make sure that you have the right cable to connect the scan-
ner to your POS or computer.
2.1 INSTALLING THE SCANNER ON A COUNTER SURFACE
Follow these steps to mount the scanner in a fixed counter surface position:
1. Locate the optimal scanner position on the counter surface. Pay attention to
the product flow, distance to the counter edge and convenience for the oper-
ator.
2. Use the enclosed templates of the vertical mount to mark the places for the
mounting holes at the counter surface and also the hole for the cable supply.
You can also choose to lead the cables away on the counter surface by
removing an insert in the back cover of the scanner.
Note:
- Use template A for installing the scanner housing landscape.
- Use template B for installing the scanner housing portrait.
3. Fasten the vertical mount to the surface with four screws (or four nuts and
bolts) as illustrated in the figure.
Installing the Pollux P-4010 13
■ The scanner and the host system must be switched off before starting the
installation of the scanner. By following this precaution you prevent any
electrical damage.
■ You are advised to install the scanner in an air circulated place out of direct
sunlight.
NOTES
SCANNER FRONT
Pollux_UserM_Deel1.qxd 14-11-2002 09:05 Pagina 13