SCANTECH ID (Champtek company) WD200 - Manual (Page 69)

Ch7. Bluetooth Configuration
BT Parameter Set Default
7.1 Scanner Mode
A>Setup SPP Master Mode
Please follow the steps to setup the communication
between the scanner and cradle.
1)
The scanner must scan “SPP Master Mode”
barcode to set the scanner in master mode.
2) Scan the Bluetooth MAC address code located
on the bottom of the cradle.
3) When the Bluetooth MAC address code was
successfully scanned, scanner will sound 3 short
beeps with green LED flash once.
4) Wait approximately five seconds for completing
the connection process with up-tone.
5) If successful, blue LED of scanner will slow flash
and the cradle will be continued on.
B>Setup SPP Slave Mode
SPP Slave Mode
Please follow the below steps to setup the
communication between the scanner and Bluetooth
application device.
1)
The scanner must scan “SPP Slave Mode”
barcode, to set the scanner in slave mode.
2) When control the Bluetooth device to search the
scanner, enter pin code (default 00:00:00) to
setup comport.
3) When scanner is successful connected, the
scanner blue LED will also blink with up-tone.
Blue LED will slowly flash to finish the setup.
66