SCANTECH ID (Champtek company) WD200 - Manual (Page 12)

9
2.2 Loop of Programming
The philosophy of programming parameters
has been shown on the flow chart of 2.1.
Basically user should
1. Scan Start of Configuration.
2. Scan all necessary labels for parameters that meet
applications.
3. Scan End of Configuration to end the programming.
4. To permanently save the settings you programmed,
just scan label for Save Parameters.
5. To go back to the Default Settings, just scan label
for Set All Defaults
.
2.3 Factory Default Settings
The factory default settings are shown with <>
and bold in the following sections. You can
make your own settings by following the
procedures in this manual. If you want to save the
settings permanently, you should scan the label of
“Save Parameters” in chapter 2.4, otherwise the
settings will not be saved after the decoder
power is off, and all settings will go back to
previous settings.
By scanning “Set All Default” label, the settings
will go back to the factory default settings.