SCANTECH ID (Champtek company) M-9030 - Manual (Page 18)

Installation
12
NOTE
• Though some cables have a power injector, this does not mean
that you must use a power supply.
• For safety reasons, an automatic switch will disconnect the
power provided by the host system, as soon as a separate
power adapter is connected to the power injector.
Changeable power plugs
To change the power plug suited to your area, follow the steps below:
1.
Press and hold the tab on the AC power adapter.
2. Remove the changeable plug outwards.
3. Replace with the desired power plug.
2.5 INITIALIZING
When using Mica for the first time, you need to initialize the communication
parameters first. Follow the steps below to initialize:
1.
Ensure that the desired interface cable is connected to Mica and your host
system.
2. Power up Mica.
3. Initialize the communication parameters by scanning the programming barcode
1.1 and 1.3 on the Configuration Guide.
NOTE
The procedure is required only once. However, when changing the
cable from one type to another, you need to perform the
procedure again.