Universal Audio UAD Plug-Ins ver.7.4.2 - Manual (Page 311)

UAD Powered Plug-Ins Manual - 311 - Chapter 29: Ocean Way Studios
Mono Output
When the plug-in has monopho-
nic output (when in a mono-out
configuration or set to mono with
the
Mono switch), the micro-
phone icon(s) in the Position
panel shows a single icon for
each active microphone, as
shown at right. This is a conve-
nient visual reminder that the
plug-in output is monophonic.
Stereo Output
When the plug-in has stereo out-
put, the microphone icon(s) in
the Position panel shows dual
icons representing the matched
stereo set for each active micro-
phone pair, as shown at right.
Each microphone signal is
routed to the left and right plug-in
channel outputs respectively.
Tip: The color of the microphone
icons matches the color of the ring around each Distance knob for visual feed-
back.
Dry/Wet When the plug-in is used in Reverb mode in a track insert (versus
effect send/return) configuration, Dry/Wet determines the bal-
ance between the original dry signal and the processed signal.
The range is from 0% (dry, unprocessed) to 100% (wet, pro-
cessed signal only).
Dry/Wet is used to set the amount of ambience when the plug-in is used in a
track insert (versus aux send/return) configuration.
Note: If Wet Solo is enabled, this control is unavailable.
Wet Solo Wet Solo puts Ocean Way Studios into 100% wet mode. When Wet
Solo is on, it is the equivalent of setting the Dry/Wet knob value to
100%.