Billet Specialties Premium Tru Trac Serpentine System - Small Block Chevy - Manual (Page 8)

Small Block Chevy Tru Trac - 13220 / 13120 www.billetspecialties.com • Tech Line 708.588.0505 15 14
Figure 9: Install Alternator
Apply anti-seize to the 10mm-1.5 x 80mm ARP 12pt. cap screw and one
8mm-1.25 x 25mm ARP 12pt. cap screw.
Place alternator between the alternator bracket and bridge bracket,
align the bottom holes.
A] Thread the 10mm ARP 12pt. fastener through bridge bracket, alternator
and into alternator bracket, finger tighten.
Rotate alternator up to align the top alternator boss with the top bridge
bracket ear.
B] Thread the 8mm ARP 12pt. cap screw through the bridge bracket and
into alternator, finger tighten.
Figure 10: Install A/C Compressor
Apply anti-seize to the following:
• Compressor shoulder bolt
• 8mm-1.25 x 25mm socket head cap screw
• 8mm-1.25 x 25mm ARP 12pt. cap screw
Place compressor with the ports up between the bridge bracket and
tensioner.
A] Thread the 8mm-1.25 x 25mm socket head cap screw through the top
hole of the tensioner and into the compressor boss, finger tighten.
B] Thread the compressor shoulder bolt with washer through the back
lower compressor boss and into the compressor bracket, finger tighten.
C] Swing the compressor up to align top compressor boss with upper
bridge bracket ear, thread the 8mm ARP 12pt. cap screw through bridge
bracket and into compressor. Tighten all compressor hardware firmly at
this time.
Next tighten bridge bracket and upper alternator fastener firmly. The
alternator boss may vary in width due to the polishing process. Check
lower alternator mount boss to see if shims are needed, .5 & 1mm shim
washers have been provided and may or may not be needed.
B
A
C
A
B