Billet Specialties Premium Tru Trac Serpentine System - Small Block Chevy - Manual (Page 2)

Spacer Nut - 1-3/4” Spacer Nut - 2-11/16”
x2
3/8-16 x 2” Socket Head Cap Screw
(Power Steering Bracket)
x2
5/16-24 x 3” Socket Head Cap Screw
(Power Steering Pump)
x2
5/16”
Lock Washer
x3
3/8-16 x 3” Block Mounting Stud
x1
x3 x1
3/8-16 x 4” Block Mounting Stud
Required Tools & Materials
Anti-seize Compound
RTV Silicone
Loc-Tite® Thread Locker
Gasket Scraper
Scotch-Brite® Pad
3/8-16 Thread Chaser* & Holder
*Thread chasers are available at your
local parts store and are different from
a thread cutting tap.
3/16” Allen
5/16” Allen
1/4” Allen
6mm Allen
PLEASE READ ALL INSTRUCTIONS BEFORE INSTALLING ANY
COMPONENTS OF THE TRU TRAC SERPENTINE SYSTEM
5/8" Combo Wrench
9/16” Combo Wrench
11/16” Combo Wrench
3/4” Combo Wrench
Socket Wrench & Extension
10mm 12pt. socket
12mm 12pt. socket
Tech Line: 708.588.0505
Fax: 708.588.7181
www.billetspecialties.com
TECH TIP:
Billet Specialties recommends the use of Anti-Seize on all
fasteners to prevent thread lock-up.
Skin Board #1 - Packaged with Power Steering Pump Skin Board #2 - Packaged with Water Pump
x2
3/8-16 Zinc Coated
Hex Nuts
(Discard After Use)
Prepping the block:
- Disconnect the battery.
- Remove the existing alternator, air conditioning compressor and
associated brackets.
- Remove all pulleys and water pump.
- Remove all traces of gasket and sealer with gasket scraper and
Scotch Brite® pad.
- Clean threads in block by chasing with a 3/8-16 thread chaser.