Billet Specialties Premium Tru Trac Serpentine System - Small Block Chevy - Manual (Page 7)

Small Block Chevy Tru Trac - 13220 / 13120 www.billetspecialties.com • Tech Line 708.588.0505 13 12
Figure 7: Install Tensioner
Apply anti-seize to two 8mm-1.25 x 25mm socket head cap screws.
Place tensioner as shown on remaining exposed spacer nut and tensioner
support bracket.
A] Thread the first 8mm socket head cap screw through the bottom hole
of the tensioner housing and into the tensioner support bracket.
B] Thread the remaining 8mm socket head cap screw through the middle
hole on the tensioner housing and into the spacer nut.
Tighten both fasteners firmly at this time.
A B
A
B
Figure 8: Install Power Steering Pump with Pulley
Apply anti-seize to the two 5/16-24 x 3” socket head cap screws.
Place power steering pump with pulley on power steering bracket and
align holes.
A] Thread one 5/16-24 x 3” socket head cap screw with lock washer
through the top holes on power steering pump and into bracket.
B] Thread the remaining 5/16-24 x 3” socket head cap screw with lock
washer through the bottom holes on pump and into bracket.
Tighten both fasteners firmly at this time.
Warning
Do not run engine without first installing power steering reservoir,
hoses and high quality power steering fluid then bleed system.
Failure to do so will severely damage the pump and void warranty.