Billet Specialties Premium Tru Trac Serpentine System - Small Block Chevy - Manual (Page 10)

Small Block Chevy Tru Trac - 13220 / 13120 www.billetspecialties.com • Tech Line 708.588.0505 19 18
Figure 14: Install Serpentine Belt & Tensioner
Pulley
A) Route belt as shown minus tensioner
pulley.
B) Place a 5/8” box end wrench on tensioner, align belt onto grove of
tensioner pulley.
C) Pull up on wrench until tensioner pulley hole lines up with boss on
tensioner, slide pulley onto boss and slowly lower wrench to apply tension
to serpentine belt.
D] Apply anti-seize to the threads of the 3/8-16 x 1/2” ARP 12pt. cap screw
and thread it through the aluminum washer (packaged with tensioner
pulley) into tensioner boss and tighten firmly (46 ft/lbs.).
Figure 15: Install Compressor Manifold
If you are going to be installing your air conditioning hoses and charging
the system at this time, remove the cover plate on top of the
compressor body.
A,B] Apply anti-seize to the remaining two 8mm-1.25 x 25mm socket head
cap screws. Install compressor manifold onto compressor and thread the
two 8mm socket head cap screws through the manifold and into the
compressor, tighten firmly (25 ft/lbs.)
Install hoses, connect clutch wire and charge system.
Important
If you are NOT installing hoses and charging the system at this time, place
the compressor manifold and hardware in a safe place and leave cover
plate on compressor. Do not connect the clutch wire or apply power to
clutch wire without the hoses connected and the system charged –
Serious damage will occur to compressor.
Compressor Oil
Although the compressor is supplied with oil, the level may not be correct
for the entire system. Consult the instruction manual of the air
conditioning unit for proper levels and system charging procedure.
Apply anti-seize to the remaining two 8mm-1.25 x 25mm
socket head cap screws.
B
C
D
A
A
B
WITH POWER STEERING WITHOUT POWER STEERING