Billet Specialties Premium Tru Trac Serpentine System - Small Block Ford User Manual

Page 8

www.billetspecialties.com

Figure 9: Complete Water Pump Installation

A] There are now five open holes remaining in the water pump, starting at the
top hole thread the 5/16-18 x 1-1/4” ARP 12pt. bolt and 5/16” flat washer into
hole and finger tighten.

B] Working in a clockwise direction, thread a 5/16-18 x 3” ARP 12pt. bolt and
5/16” flat washer into the next hole and finger tighten.

C] Continuing in a clockwise direction thread a 5/16-18 x 2-1/4” ARP 12pt. bolt
and 5/16” flat washer into the bottom right hole in the water pump and finger
tighten.

D] Thread a 5/16-18 x 1-1/4” ARP 12pt. bolt and 5/16” flat washer into the bottom
left hole in the water pump and finger tighten.

E] Moving on to the remaining hole in the water pump at the top, thread a
5/16-18 x 4-1/4” ARP 12pt. bolt and 5/16” flat washer into the hole and
finger tighten.

Tighten all bolts on the timing cover and then water pump at this time.

Figure 10: Oil Pan Installation (If Removed)

Install oil pan and gasket at this time, thread two 5/16-18 x 1/2" hex head cap
screw through the holes nearest the crankshaft and into the timing cover.

Thread the two remaining 1/4-20 x 1/2" hex head cap screws through the
corner holes of the oil pan into the timing cover.

Tighten all bolts at this time.

Note: Some aftermarket oil pans may require different length hardware.

Figure 10: Oil Pan Installation (If NOT Removed)

Tighten oil pan to motor and timing cover firmly