Billet Specialties Premium Tru Trac Serpentine System - Small Block Ford - Manual (Page 10)

www.billetspecialties.com www.billetspecialties.com
19
Figure 14: Install Bridge Bracket
Place the bridge bracket on the motor & align.
A,B] Apply anti-seize to the two 8mm-1.25 x 25mm ARP bolts and thread through
the bridge bracket into the driver side spacer nuts and finger tighten.
C] Apply anti-seize to the remaining 8mm-1.25 x 25mm ARP bolt and thread
through the bottom passenger side hole on the bridge bracket and into the
bottom spacer nut. Finger tighten.
D] Apply anti-seize to the 8mm-1.25 x 25mm flat socket cap screw and thread
through the bridge bracket into the remaining spacer nut on the passenger side
and finger tighten.
A
B
C
D
Figure 15: Install Tensioner
A] Apply anti-seize to the 5/16-18 x 1” socket set screw and thread into the back
of the tensioner. Apply anti-seize to the remaining threads on stud.
B] Thread the tensioner coupler spacer nut onto the tensioner and tighten.
C] Slide coupler nut back against the tensioner body.
D,E] Apply anti-seize to the two 8mm-1.25 x 30mm flat socket cap screws. Thread
through the bridge bracket into the tensioner and tighten.
A
B
C D E