Billet Specialties Premium Tru Trac Serpentine System - Small Block Ford - Manual (Page 6)

www.billetspecialties.com www.billetspecialties.com
11
Figure 5: Install Timing Cover & Gasket
Apply a thin film of RTV to back of timing cover and engine block surface.
A] Align and install timing cover gasket to block. Place timing cover over studs
and crank snout.
B] Thread one 5/16-18 x 2-1/4” ARP 12pt. bolt into driver side bottom hole on
timing cover and finger tighten.
Figure 6: Install Factory Timing Marker
A,B] Take factory steel timing marker and install one 5/16-18 x 2-1/4” ARP 12pt.
bolt through bottom hole of timing marker and thread into timing cover.
Thread one 5/16-18 x 2” ARP 12pt. bolt into other hole and finger tighten both
bolts.
C] Thread one 5/16-18 x 2” ARP 12pt. bolt into remaining driver side bottom hole
in timing cover and finger tighten.
If you did not remove the oil pan?
D] Install two 5/16-18 x 1/2" hex head cap screw through the holes nearest the
crankshaft and into the timing cover. Thread the two remaining 1/4-20 x 1/2" hex
head cap screws trough the corner holes of the oil pan into the timing cover.
Make sure corner gaskets line up with holes. Corner gaskets may need to be
trimmed to allow gaskets to sit flush with engine and
timing cover.
B
A
B
C
D A