SENA LS100M-SK - Manual (Page 21)

21
2.4.2 ‘get’Command
With ‘get’ command, users can view the current parameter values and status of the LS100M. Basic
‘get’command usage is as follows:
get [group] +
where,
group = 'ip','host','serial', 'admin' or 'status'
- If group is specified, shows settings of the group.
- If group is omitted, shows settings of all groups.
The group means the category where parameters belong to as like ‘set’ command. For example, if
users want to view parameter values related to IP configuration, get command as Figure 2-15
can be used.
> get ip
IP_mode: static
IP_address: 192.168.1.100
Subnet_mask: 255.255.255.0
Gateway: 192.168.1.1
>
Figure 2-15. Getting ip configuration screen
‘status’ group is a special group where ‘set’ command does not apply. ‘get status’will show current
system status screen.
> get status
Serial_no.: LS100M -0207_test
MAC_address: 00-01-95-77-88-99
F/W_REV.: V1. 2.0
Current_IP: 192.168.0.125
>
Figure 2-16. Getting status screen
If group is omitted, get command will show all of the parameter values as shown in Figure 2-17.
> get
--- Status ---
Serial_no.: LS100M -0207_test
MAC_address: 00-01-95-77-88-99
F/W_REV.: V1. 2.0
Current_IP: 192.168.0.125
--- Admin ---
Username: admin
Password: admin
Devicename: LS100M Devi ce
--- IP ---
IP_mode: dhcp