SENA HD1100 User Manual
Page 18
Starter Kit and User Manual for the HelloDevice 1100
15
Remove the corresponding item to the current HelloDevice information by using the following command.
>> arp –d 192.168.1.15
Now, you are ready to initialize current IP address of HelloDevice.
Go to [IP Setup] window and click [IP Clear] button to display a window where you can clear the IP address. If
you want to clear the current IP address of 192.168.1.15, just enter the current setting of the IP address as shown
below in figure 4.10 and click [OK] button. Then, the present IP address of 192.168.1.15 set on HelloDevice will
be changed to factory default of 0.0.0.0.
Figure 4.10 IP address Clear window
(2) Verifying the initialization of an IP address
Check if Tx LED of HelloDevice blinks. When an IP address is initialized, the HelloDevice will send the
BOOTP request message. The Tx LED of the HelloDevice will keep blinking.
(3) Resetting an IP address
To reset an IP address to 192.168.1.18, edit/modify the contents of the IP address database using the [Edit]
function and repeat the procedures of setting an IP address in section 4.3.1.
Figure 4.11 IP address change using the [Edit] function in the IP address database