Ocean Optics LIBS Imaging Module - Manual (Page 4)

LIBS Imaging Module Installation and Operation Instructions
2. Insert one end of the FireWire cable through the hole in LIBS Imaging Module cover and plug
it into either FireWire port on the PixeLINK camera. Plug the other end of the cable into the
FireWire port on your PC.
3. Plug in the 12 VDC power supply as shown below. There is no need to open the door of the
LIBS Imaging Module.
4. Insert the laser mounts onto the mounting rods on top of the LIBS Imaging Module and slide
it into position.
4 163-00000-000-01-0705