Ocean Optics LS-450 - Manual (Page 11)

009-00000-450-02-201105 1
Chapter 2
LS-450 Standalone Version
Set-up and Operation
Overview
The LS-450 Standalone version connects to the spectrometer via an interface cable. An SMA 905
connector enables coupling to fiber optics. For an S2000 Spectrometer, you can configure the light source
to operate through a jumper block on the source or on the circuit board of the spectrometer.
Package Contents
Your LS-450 Stand-alone version package should contain the following:

LS-450 Blue LED Pulsed Light Source

DB-15 accessory cable

Power supply
Connecting the LS-450 Standalone Version
► Procedure
To set up your LS-450 stand-alone version,
1. Plug the wall transformer into a standard 110V outlet.
2. Connect the power cord to the power input on the LS-450.
3. Connect an optical fiber to the SMA 905 connector to the LS-450.
4. Connect the other end of the optical fiber to the SMA 905 connector on your spectrometer or
sampling device.