Ocean Optics SIR Series - Manual (Page 4)

07-December-2010
4.0 Initial Start up of the Software:
Once the software is installed, plug in the USB cable between the spectrometer
and the host computer. Then connect the included 5Volt Power Supply. Once the
drivers are installed correctly, the spectrometer will show up in the Device
Manager as shown in Figure 1.
Select the MIR Plus application from the program menu.
Figure 2:
At initial startup of the MIR software, the spectrometer will come up and find the
home position. This will take a few seconds every time the spectrometer starts
up.
After starting the software, and the encoder position has found its home location
the software interface will appear.